onsdag 20 november 2013

Circuit Switched Data


http://en.wikipedia.org/wiki/Circuit_Switched_Data

Circuit Switched Data

From Wikipedia, the free encyclopedia
Circuit Switched Data (CSD) is the original form of data transmission developed for the time division multiple access (TDMA)-basedmobile phone systems like Global System for Mobile Communications (GSM). CSD uses a single radio time slot to deliver 9.6 kbit/sdata transmission to the GSM Network and Switching Subsystem where it could be connected through the equivalent of a normalmodem to the Public Switched Telephone Network (PSTN) allowing direct calls to any dial-up service. For backwards compatibility theIS-95 standard also supports CDMA Circuit Switched Data however unlike TDMA there are no time slots, all CDMA radios can be active all the time to deliver up to 14.4 kbit/s data transmission speeds. With the evolution of CDMA to CDMA2000 and 1xRTT the use of IS-95 CDMA Circuit Switched Data declined in favour of the faster data transmission speeds available with the newer technologies.
Prior to CSD, data transmission over mobile phone systems was done by using a modem, either built into the phone or attached to it. Such systems were limited by the quality of the audio signal to 2.4 kbit/s or less. With the introduction of digital transmission in TDMA-based systems like GSM, CSD provided almost direct access to the underlying digital signal, allowing for higher speeds. At the same time, the speech oriented audio compression used in GSM actually meant that data rates using a traditional modem connected to the phone would have been even lower than with older analog systems.
A CSD call functions in a very similar way to a normal voice call in a GSM network. A single dedicated radio time slot is allocated between the phone and the base station. A dedicated "sub-time slot" (16 kbit/s) is allocated from the base station to the transcoder, and finally another time slot (64 kbit/s) is allocated from the transcoder to the Mobile Switching Centre (MSC).
At the MSC, it is possible to use a modem to convert to an "analog" signal, though this will typically actually be encoded as a digitalpulse-code modulation (PCM) signal when sent from the MSC. It is also possible to directly use the digital signal as an Integrated Services Digital Network (ISDN) data signal and feed it into the equivalent of a remote access server.
GSM data transmission has advanced since the introduction of CSD:

Availability[edit]

The T-Mobile system is area/city specific. It works in Denver, ColoradoSavannah, Georgia, Washington, DC, and Miami, FL and Las Vegas into SoCal roaming onto Cingular. There is no service in Sarasota, Florida or anywhere in Texas. Fax services required a second number for an additional $10/mo.
The AT&T Mobility GSM EDGE network supports CSD in legacy Cingular and AT&T Wireless footprint areas. It is not generally available but can be provisioned for selected customers with specific needs requiring the service.
Currently in Australia, CSD is only available on Mobile Plans with VodafoneOptus and Telstra, however Telstra is in the process of shutting down their CSD network as of the 4th May 2010.[1]
In the UK CSD is available with all of the mobile networks but may require activation by the networks customer service team. CSD is commonly used in the UK for early smart metering deployments and as such there are no real plans to decommission or remove access to this part of the 2G network.[citation needed]

See also[edit]

Inga kommentarer:

Skicka en kommentar